engine coolant AUDI A6 1996 C5 / 2.G AEB ATW Engines Turbocharger System Workshop Manual
Page 41 of 50
21-31
- Remove intake air duct between cowl and air
cleaner housing.
- Remove air cleaner housing cover.
- Remove the following lines/harness connectors:
1 - At wastegate bypass regulator valve -N75-
2 - At Evaporative Emissions (EVAP) purge regulator valve -N80-
3 - At power output stage -N122-
4 - At Mass Air Flow (MAF) sensor -G70-
- Remove hose connections and remove air cleaner housing (arrows).
- Remove engine covers.
- Unbolt crankcase ventilation hose -1- at cylinder head cover and heat
shield.
- Unbolt both oil supply line bolts -3-.
- Remove heat shield -4-.
- Remove sleeve -2- from coolant return hose.
Pa
ge 41 of 50 Turbochar
ger s
ystem
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.21.1
Page 45 of 50
21-33
Note:
Add oil to turbocharger through oil supply line
connection flange.
- Fill up coolant Page 19
-4 .
WARNING!
The cooling system is pressurized when the
engine is warm. When opening the expansion
tank, wear gloves and other appropriate
protection, cover the cap with a cloth and
open carefully to relieve system pressure
slowly.
Note:
After installing the turbocharger, let engine idle
for approx. 1 minute without increasing engine
speed. This ensures adequate oil supply to the
turbocharger.
- Check engine oil level Page 17
-27
.
Pa
ge 45 of 50 Turbochar
ger s
ystem
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.21.1